Each 2X2 comes with two types of keys: a key fob and a securing key. The key fob is used to turn the bike on or off, while the securing key activates the steering lock and the power supply lock.
Powering the Bike
The key fob will turn the 2X2 on but the kill switch is used to change between ACC
and RUN modes.
ACC mode: The LCD display will turn on but the throttle is inactive.
RUN mode: Throttle is activated and the lights turn on.
- Hold the key fob button 1.5 seconds to turn the bike on in ACC mode. The display will turn on and N is illuminated.
- If you're ready to ride, straddle the bike and retract the kickstand, then press the kill switch to enable RUN mode. The headlight will turn on. Twist the throttle towards you to go.
- Once stopped, press the kill switch to turn the bike back to ACC.
- To turn bike off from ACC, hold the key fob button for 1 second or hold the kill switch for 2 seconds.
- To turn bike off from RUN mode, hold either the key fob or the kill switch button for 2 seconds.
Security Mode
Security Mode determines whether the key fob is required to power the bike. Security Mode is on by default, meaning the key fob is required to turn the bike on.
To turn Security Mode OFF: This enables the bike to be powered without the key fob; the bike is only turned on using the kill switch.
Warning: Turning off Security Mode will allow anyone with access to the bike to turn it on and use it.
This process can only be performed using a fob that is already paired to the bike.
- Turn off the bike.
- Press and hold both the key fob button and the kill switch for approximately 10 seconds.
- The bike will beep a few times while the buttons are held and then give one final long beep to indicate programming is complete.
- The bike can now be turned on using only the kill switch.
- To turn Security Mode back on, repeat the above steps.